What do you cover a patio with?

Cover it with any kind of solid roofing, such as plywood and shingle or corrugated plastic roofing, if you want a more protective shelter. You can match the roofing to the roofing on your home, if you attached the patio cover to the side of it, in order to make it appear as just an extension of the home’s roof.

How to Improve an Uneven Concrete Patio

  1. Wash dirt and loose debris off the concrete patio with a pressure washer.
  2. Put on a face mask and eye goggles.
  3. Sweep away all loose debris and sanding particles with a push broom.
  4. Spread an even coat of bonding adhesive over the surface of the concrete patio with a long paint roller.

Furthermore, how do you make a tarp patio cover? Tips

  1. Some grommet kits include a hole cutter. Place scrap wood under the tarp where you want a new grommet, and center the hole cutter above that mark.
  2. Tarps are not waterproof, only water-resistant. Install the tarp at an angle so rain flows off its lowest edge.
  3. If possible, lash the tarp around all four sides.

Then, how do you make a homemade covered patio?

Building a Covered Patio

  1. Step 1 // Install Anchors & Column Brackets.
  2. Step 2 // Build the Header Beams.
  3. Step 3 // Install the Columns.
  4. Step 4 // Install the Header Beams.
  5. Step 5 // Cut the Roof Rafters.
  6. Step 6 // Install the Rafters.
  7. Step 7 // Cut and Install the Roof Boards.
  8. Step 8 // Install the Skylights.

How do I block the wind on my patio?

If you want to naturally block the wind from your porch, you can create a windbreak with trees or shrubs. Small trees and vertical shrubs can be planted directly against the side of the porch while a line of larger trees can be planted 15 to 20 feet away from the porch and still provide wind protection.

How do you shade a patio?

Plant trees. Shade trees are an obvious choice and an eco-friendly, inexpensive way to add shade to outdoor living areas. Add a gazebo. Invest in patio umbrellas. Stash a pop-up canopy. Install a pavilion. Include marquees in your patio design. Hang patio curtains. Construct a permanent roof.

How do you attach a ledger board to a house for a patio cover?

Attach the ledger with 1/2-inch-diameter lag screws or bolts every 16 inches (or as specified by local building codes). Slip stainless-steel washers between the ledger and the siding to allow water to flow behind the ledger. If you can’t get behind the joist to cinch down nuts, use lag screws.

How do you make patio slabs look new?

Give a tired patio or paving slabs a makeover Make sure your patio or slabs are clean and dry. That means, removing moss, algae and grease. To remove moss and algae, sweep the patio with a stiff broom. If there’s thick coverage, we suggest using a fungicide. To remove grease, use our Oil & Grease Remover.

What can I do to my concrete patio?

These concrete patio ideas will help you transform what’s typically seen as a backyard eyesore. Build a stamped concrete patio. Fake the look of stone. Get creative with paint. Install clay pavers for your patio. Stain or seal the concrete. Curate an outdoor living room for entertaining.

How can I spice up my concrete patio?

Concrete patios are very durable, but they’re just not very exciting. 6 Ways to Make Over a Concrete Patio Paint a Pattern. Lay Decking Flooring. Add Curves With Pavers. Lay Slate Tiles. Stain the Concrete to Look Like Tile. Add a Beautiful Outdoor Rug.

How do you level an uneven concrete porch?

The surface needs to be as clean as possible for the best results. Build a wooden frame around the edges of the concrete slab that protrudes 2 or 3 inches above the current level. Place a leveling layer of sand on the surface to cover any depressions and tamp it down so that it will settle once the concrete is poured.

Can you lay a patio over an existing patio?

Under the right conditions and with proper preparations, you can put paver stones over a concrete porch or patio to create a new, fresh surface that is both functional and aesthetically pleasing.

How do you fill large cracks in concrete patio?

How to Repair Wide Concrete Cracks Chisel the crack with a hammer and masonry chisel to widen the base of the crack and to dislodge any loose material from the old concrete. Remove all debris from the crack, using a wire brush. Remove all water and debris from the crack with a wet/dry shop vacuum or a brush.

How do you fix an uneven flagstone patio?

How to Fix Uneven Flagstone Step 1: Set up a level mason string line that will test if all of the stones are even. Step 2: Use a rubber sledge hammer to impact any stones that are slightly too high. Step 3: Remove the stones that have shifted significantly and you aren’t able to get back in place by using your rubber sledge.