How do you reset a gatehouse deadbolt?

There is no Gatehouse Electronic deadbolt reset code. Remove the cover of the inside locking mechanism and locate the “set” button for two seconds until you hear the beep. This is how you change the code on your Gatehouse door lock.

Perform a factory reset

  1. Remove battery pack.
  2. Press and HOLD the Program button while reinserting the battery pack.
  3. Press the Program button once more.
  4. Perform the door handing process again to teach the lock the orientation of the door.

Similarly, how do you change the code on a gatehouse deadbolt? This is how you change the code on your Gatehouse door lock.

  1. Enter your 6-digit programming code and hit the lock button.
  2. Enter “30” and hit the lock button.
  3. Enter 1-2-3-4-5-6 and then the lock button to delete this default user code.
  4. Wait ten seconds for the light to go off.

Furthermore, how do I reset my digital door lock?

How to Change the Code on a Digital Door Lock

  1. Refer to the manufacturer’s instructions for your lock to remove it from the door if it is still installed.
  2. Turn the lock over so that the keypad is facing downward.
  3. Examine the back of the lock and locate the screws that hold the back cover on.
  4. Lift the back plate carefully off of the lock and set it aside.

How do you reset a Kwikset electronic deadbolt?

You can factory default your Kwikset Z-Wave Lock by removing the lock’s cover and then removing the lock’s battery pack to power the lock down. Then press and hold the “Program” button. Keep the button held down as you reapply power to the lock. Then wait, and press one more time to reset.

How do you reprogram a Kwikset door lock?

Press the PROGRAM button once, enter your new 4 – 8 digit code and then press the LOCK button. 2. Press the PROGRAM button twice, enter the same or a new code and then press the LOCK button once. If your old code still remains in the unit, you will need to perform a hard reset of the unit.

How do I factory reset my Kwikset 909?

Press and HOLD the Program button while reinserting the battery pack. Keep holding the button for 30 seconds until the lock beeps and the status LED flashes red.

How do you put a Kwikset lock in pairing mode?

To connect a Z-Wave Kwikset lock in the SmartThings Classic app Tap My Home. Under Things, tap Add a Thing at the bottom of your Things list. The app will say Looking for devices… While the Hub searches, Remove the battery cover. Press the “A” button once.

How do you reset a Kwikset Powerbolt 2?

How to restore default settings on my Powerbolt 2? Perform a factory reset Make sure the door is open and unlocked. Enter the default Mastercode (O-O-O-0). Press the lock button. Press 0. Press the lock button. Test the lock: With the door open and unlocked, Press the lock button.